Great Plains V-300F Operator Manual - Manual (Page 57)

Great Plains Manufacturing, Inc. Monitor Operation 53
11/15/2007 148-057M-A
Set Implement Width
In order for the instrument to accumulate area correctly,
the implement working width must be programmed. The
correct figure is:
3.000 meters (Metric units mode) or
118.1 inches (Imperial units mode).
Note: The factory default is 4.000 (meters) or 157.5 (inch-
es), and is not correct for the V300/V300F
1. Channel Select to Area Total .
2. Press and hold to enter Program Mode 1.
The units of measure display (see page 47) appears
for a few seconds. Continue holding the button until a
numeric display appears.
3. While continuing to hold , use Channel Select
to select a digit, and then the decimal point.
Continue to hold to cycle slowly between 0-9
and decimal point positions. Release at desired
values.
4. While continuing to hold , press again to
select the next display element, and hold to change.
Repeat until the desired value is entered.
5. Release to save the new values.
Figure 53
Set Implement Width
22632