Great Plains V-300F Operator Manual - Manual (Page 59)

Great Plains Manufacturing, Inc. Monitor Operation 55
11/15/2007 148-057M-A
Tramline Sequence/Bout Selection
1. If tramlining has been disabled, re-enable it before
selecting the sequence. See page 56.
2. Channel Select to Tramline .
Select The Sequence
Refer to Figure 54
3.
Press and hold to enter Program Mode 1.
After 3 seconds the first two characters flash, indicat-
ing the tramline sequence currently set.
4. While continuing to hold , hold Channel Select
to select the required sequence. Release only
the button when the sequence is set.
Select the Tramline Bout
Refer to Figure 55
5.
While continuing to hold , press and release the
button to toggle between the tramline sequence
and tramline bout number display. The 3rd and 4th
characters flash indicating the tramline bout number
currently set.
6. Press and hold the button to cycle tramline the
bout from .01 to .15.
Note: Setting the bout to “.00” disables the tramline func-
tion. In normal mode, the indicator chevron may not
index to the tramline function. To re-enable tramlin-
ing, see page 56.
Note: If either asymmetric left (“AL.”) or asymmetric right
(“Ar.”) sequences are selected, the tramline out-
put is also switched on for the bout following the tar-
get bout (i.e. bout 1).
If the special asymmetric sequence (“AS.”) is se-
lected, the only options for the tramline bout num-
ber are .10, .18 and .20.
7. Release all buttons.
SY. SYmmetric Bouts .01 to .15
AL. Asymmetric Left Bouts .01 to .15
Ar. Asymmetric right Bouts .01 to .15
AS. Asymmetric Special Bouts .10, .18, .20
Figure 54
Tramline Sequence Selection
22632
Figure 55
Tramline Bout Selection
22632