Great Plains V-300F Operator Manual - Manual (Page 53)

Great Plains Manufacturing, Inc. Monitor Operation 49
11/15/2007 148-057M-A
Forward Speed Function
If the Tramline function is disabled, forward speed is the
default display in normal mode.
If the Tramline function is enabled (the factory default),
Channel Select
to Forward Speed .
Forward Speed displays for 10 seconds before returning
to the Tramline Display.
The displayed speed is in the current units of measure
(kph or mph). See page 47 to change.
Forward Speed Alarm
If you stop while the drill is in work, or move at a speed
less than 2.6 kph (1.6 mph), the instrument beeps twice,
and the display alternates between the currently selected
channel and the Forward Speed channel (which displays
0.0).
The alarm continues until the speed is increased above
the alarm threshold.
Disable Forward Speed Alarm
1.
Power-off the console using its rear panel switch.
2. Press and hold the button while re-applying
power. This enters Program Mode 2 “CAL.2”.
3. Release the button when the indicator chevron
is over the Forward Speed channel .
Refer to Figure 49
4.
Press and release Channel Select to alternate
between:
0 = Forward Speed Alarm OFF, and
1 = Forward Speed Alarm ON
5. Remove and re-apply power to save the selection.
The instrument resumes normal mode at next
power-on.
Figure 48
Typical Forward Speed (kph)
22632
Figure 49
Forward Speed Alarm On
22632