Great Plains V-300F Operator Manual - Manual (Page 52)

48 V300 & V300F Great Plains Manufacturing, Inc.
148-057M-A 11/15/2007
Units
The instrument is factory preset for Metric entry/display,
and can be set to Imperial units (use Imperial for U.S.
customary units).
Functions affected by units mode are:
The instrument remains in the selected units mode until
changed. Any values previously entered or stored for
other functions are converted to the new units, and need
not be re-entered.
To determine the current units mode, Channel Select
either the Forward Speed Area Total channel,
then press and hold the button.
Either the top row of horizontal segments (Metric) or the
bottom row of horizontal segments (Imperial) will briefly
display, indicating the units selected.
Changing Units of Measure
1. Power-off the console using its rear panel switch.
2. Press and hold the button while re-applying
power. This enters Program Mode 2 “CAL.2”.
3. Release the button when the indicator chevron
is over the Area Total channel icon.
4. Press to switch between Metric and Imperial
units.
5. Remove and re-apply power to save the selection.
The instrument resumes normal mode at next
power-on.
Function
Top Bars
= Metric
Bottom Bars
= Imperial
Forward Speed kph mph
Area Ha acres
Width/S.S.F. meters inches
Figure 46
Metric Mode Selected
22632
Figure 47
Imperial Mode Selected
22632