Great Plains V-300F Operator Manual - Manual (Page 48)

44 V300 & V300F Great Plains Manufacturing, Inc.
148-057M-A 11/15/2007
Passes are automatically counted at each drill lift operation. Tramline bouts are automatically applied, unless overrid-
den from the console.
The system has two memory registers (Total.1 and Total.2) to record area worked. The area is accumulated to both
memory registers. Area totals and all calibration data are retained in memory when the instrument is powered off or
disconnected from the drill.
The instrument must be initially calibrated to suit the implement being controlled. Three program modes allow the
default settings to be altered as required. Most of these settings do not need to be revised in normal use.
2. Tramlining is the selective disabling of seeding in rows that are to be in the tire tracks of a sprayer that to be employed post-panting, or
even post-emergence. Different rows (or no rows) are automatically disabled on each pass by clutches controlled by the monitor.