beautypg.com

Material clean-out, Hopper clean-out – Great Plains YP1625 Operator Manual User Manual

Page 82

background image

78

YP1225 and YP1625

Great Plains Manufacturing, Inc.

401-226M-A

03/12/2012

Material Clean-Out

When planting is completed, it is commonly the case that
some seed remains. There may be seed in the hopper or
bulk box, seed in the airbox, a small amount of seed in
the hose lines, and seed in the meters. Some meters
may be filled up to the top cut-off vent (which prevents
additional seed from reaching that meter).

A complete system cleanout is a 3 step process.

1.

Empty airbox (and hopper, if desired).

2.

Blow residual seed to meters.

3.

Clean out meters with fan running.

Possible Dust and Chemical Fume Hazard:
Wear a respirator, and any other protective equipment speci-
fied by the seed and/or seed treatment supplier. Expect dust
and fumes during hopper clean-out.

Hopper Clean-Out

Perform hopper clean-out with the fan off.

Refer to Figure 109
1.

Close the slide gate

at the base of the hopper.

2.

Place a tarp under the seed cart.

Refer to Figure 110
3.

Open the clean-out door on the bottom of the airbox.
Seed in the airbox immediately falls onto the tarp.

Note: If needed, additional access doors are provided.

4.

Open the slide gate slowly. The remaining seed in
the hopper falls onto the tarp. Use the slide gate to
regulate the flow and, as needed, stop it while recov-
ering seed from the tarp.

5.

Tap on the sides of the hopper to dislodge residual
seed.

6.

Close slide gate.
Close clean-out door.

7.

Perform an air system clean-out to remove final
amounts of residual seed from airbox, and all seed in
meters.

Entrapment and Rapid Suffocation Hazard:
Never enter a hopper for any reason.
Keep strainer in place at all times.

A hopper that is full or merely appears full can be an

entrapment hazard. You can sink entirely into the grain, or
into an oxygen-deficient void, and suffocate in a matter of
seconds. Grain bridges and crusts are especially danger-
ous.

When hazardous fumes are present, you can be quickly

overcome even with the hopper lid open.

Do not enter a hopper for material loading, material

unloading, hopper cleaning or meter maintenance.

Clean hopper by power washing from outside hopper top.

FigureSpacer:

Figure 109

Hopper Slide Gate Open

29495

1

1

FigureSpacer:

Figure 110

Airbox Clean-Out Door Open

29494

2

This manual is related to the following products: