Tweco 500SP PowerMaster Automation - Manual (Page 34)

POWERMASTER 400SP, 500SP AUTOMATION
3-10 March 16, 2007
I. How To Configure The Power Supply
For Aluminium Welding
Change the feedrolls to U groove for aluminium wire
(refer to the Options and Accessories list in the
Appendix).
Change the torch liner to a nylon or teflon liner (refer
to the Options and Accessories list in the Appendix
and to the next section "3.07 Installing a New Wire
Conduit").
Use the correct size outlet guide to suit the wire
diameter.
.030 & .035 in. - Steel tube with red lining
.045 & 3/64 in.- Use steel tube with black lining
1/16 in. - Use clear teflon tube
Fasten the torch and insert the wire electrode.
NOTE
The parts required for the torch depends
on the type torch and
wire diameter.
Please refer to the torch spare parts list.
H. How To Refill The Cooling Fluid
Only use original MIG/TIG coolant for refill. It
provides protection against frost down to 4°F
(-20°C). If using other coolants, the coolant pump
could be damaged. Coolant circulation has to be
checked at regular intervals. Reliable coolant return
flow is essential to ensure the coolant is not lost and
the coolant cooled MIG torch is not damaged. Check
the level of the coolant every day before operating.
The coolant must be visible when the tank cap (37)
is removed.
CAUTION
Remove the pin from the breather hole in
the cap of the coolant tank as leaving the
pin in the cap may cause a coolant flow
error.
MIG/TIG Coolant 1 Quart (1 L) Part No. W4001402
MIG/TIG Coolant 1 Quart (5 L) Part No. W4001400
MIG/TIG Coolant 5 Gallon (20 L) Part No. W4001401
Art # A-06373
Coolant
Tank Cap