Tweco 42 CutMaster Operating Manual User Manual
Operating manual, Cutmaster
Table of contents
Document Outline
- 0-5141-CCR
- SECTION 1:GENERAL INFORMATION
- 1.01 Notes, Cautions and Warnings
- 1.02 Important Safety Precautions
- 1.03 Publications
- 1.04 Note, Attention et Avertissement
- 1.05 Precautions De Securite Importantes
- 1.06 Documents De Reference
- 1.07 Statement of Warranty
- 1.02 Important Safety Precautions
- SECTION 2 SYSTEM: INTRODUCTION
- 2.01 Working Principle
- 2.02 Power Supply Specifications
- 2.03 Input Wiring Specifications
- 2.04 Power Supply Features
- 2.01 Working Principle
- SECTION 2 TORCH:INTRODUCTION
- 2T.01 Scope of Manual
- 2T.02 Specifications
- 2T.03 Introduction to Plasma
- 2T.01 Scope of Manual
- SECTION 3: INSTALLATION
- 3.01 Unpacking
- 3.02 Lifting Options
- 3.03 Primary Input Power Connections
- 3.04 Air Supply Connections
- 3.01 Unpacking
- SECTION 4 SYSTEM: OPERATION
- 4.01 Control Panel
- 4.02 Preparations For Operating
- 4.03 Sequence of Operation
- 4.04 Cut Quality
- 4.05 General Cutting Information
- 4.01 Control Panel
- SECTION 5 SYSTEM: SERVICE
- 5.01 General Maintenance
- 5.02 Basic Troubleshooting Guide
- 5.01 General Maintenance
- SECTION 5 TORCH:SERVICE
- 5T.01 General Maintenance
- 5T.02 Inspection and Replacement of Consumable Torch Parts
- 5T.01 General Maintenance
- SECTION 6: PARTS LISTS
- 6.01 Introduction
- 6.02 Power Supply Replacement Parts
- 6.03 SL40 Torch Replacement Parts
- 6.04 Optional Accessories
- 6.01 Introduction
- APPENDIX 1: CUTMASTER 42 CIRCUIT DIAGRAM
- APPENDIX 2: SL40 TORCH PIN-OUT DIAGRAM
- 1.01 Notes, Cautions and Warnings
- SECTION 1: GENERAL INFORMATION
- SECTION 2 SYSTEM: INTRODUCTION
- SECTION 2TORCH: INTRODUCTION
- SECTION 3: INSTALLATION
- SECTION 4 SYSTEM: OPERATION
- SECTION 5 SYSTEM: SERVICE
- SECTION 5 TORCH: SERVICE
- SECTION 6: PARTS LISTS
- APPENDIX 1: CUTMASTER 42 CIRCUIT DIAGRAM
- APPENDIX 2: SL40 TORCH PIN-OUT DIAGRAM
- 0-5141-Rear