E-flite AT-6 Texan 25 ARF - Manual (Page 43)

43 E-flite AT-6 Texan ARF Assembly Manual
 2. Use RC-56 canopy glue to attach the canopy to
the fuselage. Use low-tack tape to hold the canopy in
position until the glue fully cures. Note that the front of
the canopy has a black strip that aligns with the anti-
glare panel on the front of the fuselage.
 3. Position the radiator scoop on the bottom of the wing
center section. A felt-tipped pen can be used to color in
the scoop to give that open look. Trim the radiator scoop
as necessary for a perfect fit and glue it only to the wing
using medium CA.
 4. Attach the landing gear fairings to the wheel struts
using two tie wraps per fairing. Use side cutters to
remove the excess material from the tie wraps. Once the
fairings have been attached with the tie straps, you can
add a small drop of Medium CA to the inside to help
secure it so it will not move in flight.