E-flite AT-6 Texan 25 ARF - Manual (Page 42)

42 E-flite AT-6 Texan ARF Assembly Manual
 11. Add (3) three inch extensions to the aileron, flap,
and retract ports of the receiver. Plug the Y-harnesses and
retract servo leads into the three inch long extensions.
 12. Secure the wing to the fuselage using the two
1/4-20 x 2-inch nylon bolts and flat blade screwdriver.
Basic Cockpit and Accessories
Required Parts
Assembled airframe Canopy
Pilot figure Radiator scoop (grey)
Landing gear fairing (2)
Required Tools and Adhesives
Medium CA RC-56 canopy glue
Felt-tipped pen Tie wrap (4)
Side cutters Low-tack tape
 1. Use medium CA to glue the pilot figure in the fuselage
as shown.