E-flite AT-6 Texan 25 ARF - Manual (Page 19)

19 E-flite AT-6 Texan ARF Assembly Manual
 11. Use a 5/64-inch (2mm) drill bit to enlarge the
outer hole in the rudder servo arm. Use a #2 Phillips
screwdriver to remove screw and the arm from the servo.
 12. Slide the bend in the pushrod through the hole in the
servo horn from the topside of the horn. Use a pushrod
connector to secure the pushrod to the horn.
 13. Slide the pushrod back into the pushrod tube and
thread the clevis back onto the pushrod. With the radio
on and the rudder stick and trim centered, secure the
servo arm to the servo. Center the rudder by threading
the clevis in or out as necessary.
 14. Repeat Steps 9 through 13 to connect the two
elevator pushrods to the elevator servos.