E-flite AT-6 Texan 25 ARF - Manual (Page 31)

31 E-flite AT-6 Texan ARF Assembly Manual
 2. Remove the servo and drill the four locations for
the servo mounting screws with a drill and 1/16-inch
(1.5mm) drill bit.
 3. Apply a few drops of thin CA to each hole to harden
the surrounding wood.
 4. Remove the servo horn from the servo. Use a #1
Phillips screwdriver to install the screws provided with the
retract servo to secure it in the wing center section.
 5. Using a hobby knife, cut a cross in the covering over
the opening for the wheel. Use a covering iron to seal
the covering tight against the wing before removing the
covering.