E-flite AT-6 Texan 25 ARF User Manual

Page 18

E-flite AT-6 Texan ARF Assembly Manual



8. Use hook and loop tape to install the receiver in the

fuselage following the manufacturer's instructions. A

tube has been installed inside the fuselage to route the

antenna wire.

Do not cut the receiver wire if it extends

excessively outside the fuselage as this will greatly reduce

the range of your radio system.



9. Physically center the rudder. Use a felt-tipped pen to

mark the rudder pushrod where it crosses the outer hole

of the rudder servo arm.



10. Remove the rudder pushrod from the fuselage and

make a 90-degree bend in the pushrod at the mark

made in the previous step using pliers. You will also have

to remove the clevis at this time as well to reinstall the

pushrod.