E-flite AT-6 Texan 25 ARF User Manual

Page 25

E-flite AT-6 Texan ARF Assembly Manual



3. Using a ruler, mark the servo cover as shown

using a pencil.



4. Position the servo so the arm is centered at the

intersection of the lines drawn in the previous step. Use a

pencil to mark the cover for the servo mounting blocks.



5. Use 6-minute epoxy to glue the servo mounting block

to the servo cover as shown. Allow the epoxy to fully cure

before proceeding.

Note: You will find the servo mounting blocks in your

kit to vary in length from the measurements listed

above. They have been cut to the correct length from

the manufacturer.