E-flite AT-6 Texan 25 ARF - Manual (Page 13)

13 E-flite AT-6 Texan ARF Assembly Manual
 3. Use a hobby knife and rotary tool to remove the area
in the center of the dummy radial engine.
 4. Use a hobby knife to remove the area between each
of the cylinders to allow cooling air to pass through the
cowling and over the motor.
 5. Use 6-minute epoxy to glue the dummy radial engine
inside the cowling.
 6. Cut four strips of card stock. Make a 1/8-inch (3mm)
hole in the end of each strip. Align the hole with the blind
nut and use low-tack tape to hold the card stock to the
fuselage.