Diode LED SPOTMOD LED Fixture - Manual (Page 2)

Plug-In Adapter Installation: Ensure main power is
turned OFF. Attach a ‘Male Wet Location to DC Adapter
Connector’ to the spot module and then connect to the
plug-in adapter. Attach additional in-line accessories.
Plug the adapter into a 120VAC receptacle and turn ON
main power.
Magnetic Dimmable Driver Installation: Ensure main
power is turned OFF. Attach a ‘Male Wet Location Splice
Cable’ to the spot module or splitter cables and hard-
wire to the dimmable driver. Refer to the Magnetic Dim-
mable Driver Installation Guide for more thorough wiring
instructions.
12/24V REIGN Dimmer Installation: Ensure main power
is turned OFF. Attach a ‘Male Wet Location Splice Cable’
to the spot module or splitter cables and hard-wire to the
REIGN Dimmer. Ensure a compatible driver is attached
to the dimmer. Refer to the REIGN Dimmer Installation
Guide for more thorough wiring instructions.
V-
(Black)
Input Output
L
N
V+
(Red)
G*
N
L
Input Output
V+
V-
Class 2 Low Voltage Driver****
Installed in Junction Box‡
REIGN 12-24V Dimmer****
W
et Location Splice Cable - Ma
le
Wet Location Splitter Plug
V+
V- AC Power
50/60Hz
AC Power
50/60Hz
120VAC Magnetic Low
Voltage Dimmer†
L N
Magnetic
Dimmable Driver††
W
et Location Splice Cable - Male
Wet Location Splitter Plug
V+ (Red)
V- (Blue) N (White)
L (Black)
Inline Accessory
(Extensions, splitters, controls, etc.)
Class 2 Low Voltage
Plug-In Adapter (Driver)
Insertion points for
DC plug accessories
Wet Location Splitter Plug
Male W
et Location to DC
Adapter Connector
AC Power
50/60Hz
INSTALLATION NOTES (see web page for larger diagrams)
* Driver may not require a fault ground connection. Refer
to driver specifications for additional information.
**** Determine the number of low voltage outputs of
the driver when installing multiple PWM controllers/dim-
mer switches. No more than one PWM controller/dimmer
switch can be attached to a single output of the driver.
† Install a compatible magnetic low voltage dimmer
switch. See dimmer switch manufacturer installation
guide for complete wiring instructions.
†† Dimmable drivers require a compatible magnetic low
voltage dimmer switch to supply the driver and fixture
with appropriate input voltage. Do not test or install di-
rectly connected to an AC power source or On/Off switch.
It is recommended to load the driver no more than 80% its
labeled rating for maximum longevity. See dimmer switch
manufacturer specifications for minimum load recom-
mendations.
‡ Refer to driver specifications for a compatible junction
box.