Diode LED Class 2 Dimmable Driver 12V 300W - Manual (Page 3)

Page 3 of 3
If dimming, please ensure a compatible MLV dimmer switch and dimmable LED fixture is installed. Incompatible dimmer switches and/or fixtures are
the most common triggers for faulty installations.
• Lights are flickering: An incompatible dimmer switch or defective driver may produce excess strobing/flickering. Ensure a compatible dimmer is
installed. See dimmer switch specs for minimum load requirements. If excess strobing/flickering is still apparent, please contact technical support.
• Reset breaker trips repeatedly: Ensure each secondary tap is not overloaded more than 50W, and the total wattage does not exceed 300W. Ensure
there is not a short circuit occurring. If the breaker continues to trip after reset then contact technical support as the driver may be defective.
• Excess voltage drop: Ensure applicable AWG wire is installed between driver and fixture. Additionally, an MLV dimmer switch will trim voltage down,
causing an output less than 12VDC. Performance will not be affected if the fixture is receiving ≥ 10.5VDC. Use the Orange Boost Tap (see ‘Boost Tap’)
as an optional voltage boost in place of the Black (Line) wire if the fixture is receiving noticeable light degradation. Cap the existing hot wire not in
use.
Troubleshooting
For additional questions/concerns please contact technical support. We are more than happy to assist you with any technical difficulties or concerns.
12V 300W CLASS 2 MAGNETIC DIMMABLE DRIVER INSTALLATION GUIDE
V2.1