Autocue WinCue Pro News - Manual (Page 125)

WINCUEPRONEWS USER GUIDE
VERSION 1.30B515 125  QTV 1998
SECAM
To configure the I.M.T. card for SECAM composite video output use the same jumper setting
as PAL on J11. In the WinCueProNews software, from the Prompt menu choose
Configuration then Prompt Engine and ensure that Colour Burst is disabled. These settings
will generate a mono composite output.
A7 External Power Supply - J12
In systems where the I.M.T. card is not fitted inside the PC, it is powered by an external
power supply. This power supply is connected to J12. This appears as an 8-pin connector on
Issue 1 cards, and a 3-pin connector on Issue 2 cards.
If you need further information about powering the I.M.T. card from an external power supply
please contact your supplier.
A7 Composite Video Features Connector - J10
The Composite Video Features connector allows additional 4 composite video ports to be
added to your PC. To find out more about this product contact your supplier.
Do not attach anything to any of the pins on J10.
A7 Other Jumpers
J1 and J5
J1 is the debug port. It supplies serial debugging information. Do not attach anything to any of
its pins.
J5 is the flash reset port. Do not attach anything to any of its pins.