Rockwell Automation DeviceLogix System User Manual - Manual (Page 178)

178 Publication RA-UM003B-EN-P - February 2010
Appendix B RSNetWorx for DeviceNet Software and the DeviceLogix Editors
Check General Information
The device properties dialog box opens to the General properties
dialog. If you are in another dialog in the device properties dialog
box, click on the General tab to return to the General dialog.
The General window is common to both DeviceLogix-enabled devices
and non-DeviceLogix-enabled devices. For DeviceLogix devices, you
should make special note of the Address and Revision fields.
Set the Node Address
The address in this window must match the physical address on the
module. If you added your devices off line, you most likely need to
adjust the addresses of the devices. If you need to adjust the address:
1. Click once in the Address box.
2. Change the number of the address so that it matches the
physical address on the module.
3. Click OK.
TIP
The DeviceLogix tab is available on the General properties
window when a DeviceLogix EDS file is registered for the
current device.