Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 4)

II SP600 AC Drive User Manual
2.8 Remote Operator Interface .......................................... 2-23
2.8.1 Connecting the Remote OIM or VS Utilities to the
Drive .................................................................. 2-23
2.9 PC-Based Utility........................................................... 2-24
Chapter 3 Mounting the Drive
3.1 General Requirements for the Installation Site .............. 3-2
3.1.1 Verifying Power Module AC Input Ratings Match
Available Power................................................... 3-2
3.1.1.1 Unbalanced or Ungrounded Distribution
Systems ................................................ 3-3
3.1.1.2 Input Power Conditioning...................... 3-4
3.1.2 Making Sure Environmental Conditions are Met . 3-5
3.1.3 Minimum Mounting Clearances ........................... 3-6
3.1.4 Drive Dimensions and Weights........................... 3-7
3.2 Mounting the Drive....................................................... 3-12
3.2.1 Verifying the Drive’s Watts Loss Rating............. 3-15
Chapter 4 Wiring Requirements for the Drive
4.1 Power Wiring.................................................................. 4-1
4.1.1 Power Wire Sizes ................................................ 4-3
4.1.2 Using Input/Output Contactors ............................ 4-4
4.2 Control and Signal Wire ................................................. 4-5
4.3 Recommended Motor Lead Lengths.............................. 4-5
4.3.1 Reflected Wave Compensation ........................... 4-7
4.4 Selecting Input Line Branch Circuit Protection............... 4-9
Chapter 5 Finding Wire-Routing Locations and Grounding the Drive
5.1 Routing Input, Motor Output, Ground, and
Control Wiring for the Drive ........................................... 5-1
5.2 Grounding the Drive....................................................... 5-3
Chapter 6 Installing Power Wiring
6.1 Removing and Replacing the Cover .............................. 6-1
6.1.1 Removing and Replacing the Cover on NEMA 1
Drives .................................................................. 6-1
6.1.2 Removing and Replacing the Cover
on NEMA 4x/12 Drives ........................................ 6-2
6.1.2.1 Locking the Cover................................. 6-4
6.2 Installing Output Power Wiring....................................... 6-5
6.3 Installing Input Wiring..................................................... 6-6
6.3.1 Installing an Optional Transformer and Reactor .. 6-6
6.3.2 Installing Branch Circuit Protection...................... 6-7
6.3.3 Installing the Required External/Separate Input
Disconnect........................................................... 6-7
6.3.4 Installing Power Wiring from the AC Input Line
to the Drive’s Power Terminals ........................... 6-7
6.4 Dynamic Braking Connections....................................... 6-9