Rockwell Automation SP600 AC Drive User Manual Version 1.0 - Manual (Page 109)

Using the LCD OIM 9-11
about setting the display timeout period.
9.8.1 Displaying and Changing the OIM Reference
You can display the reference value that the OIM is sending to the
drive by pressing the up or down arrow key once when the process
display screen is active. See figure 9.10. The OIM reference can be
used for the speed reference, PI reference, or trim reference.
To change the displayed reference, press and hold down either the
up or down arrow key until the desired value is displayed. Release
the key to return to the process display screen.
Note that changing the value of the OIM reference does not affect
the value of any other port reference.
The value of the OIM reference is saved through a power cycle if
parameter 192 (Save OIM Ref) is set to Save at Power Down.
Figure 9.9 – Process (User) Display Screen
P0: SP600
Auto Stopped
Fltq
0.00 Volts
Amps
Hz
0.00
0.00
Customize up to
eight F-Key labels
Select up to
three process
variables to
monitor, and
customize the
text displayed
Scale the output
values to suit the
application
>>
Man
Figure 9.10 – OIM Reference Displayed
Man
P0: SP600
>> Auto Stopped
Fltq
0.00 Volts
Amps
Hz
0.00
0.00 OIM Ref
0.00 Hz