Rockwell Automation VSM500 Integrated Drive/Motor - Manual (Page 15)

Step 1 - Identify Your Unit 1-5
1.2.5 Operating the Unit Using the Local Operator Controls
Important: If the local operator controls are disconnected from or connected to the
unit after power up, the unit will stop due to a non-resettable fault. Refer to
chapter 11 for information about faults.
1.3 Option Kits
Table 1.2 lists the VSM500 option kits.
Desired Action User Steps
Start the unit.
1
1 If the unit is set up for terminal block control (see section 8.3.9), the and keys are not functional.
Press the green key.
Stop the unit.
Press the red key.
Change the direction of motor rotation. 1 Press the key.
Clear faults.
Press the key.
Decrease the speed reference.
2
2 If the unit is using a preset speed reference (see section 7.4.1) or terminal block speed reference (see
section 8.3.2), pressing the or key will have no effect on unit operation.
Press the key until the speed reference displayed is the desired value. The
longer the key is held down, the faster the value decreases.
Display the current speed
reference
Press the or key once.
The display returns to indicating speed in RPM or %load after three to five
seconds. (Note that holding down either key will change the speed reference.)
Display the speed in RPM No action required; speed in RPM is the default display based on status of
terminal 12 (see section 7.4).
If the or keys are not pressed for several seconds, the display returns
to indicating actual motor speed in RPM.
Display %load Close contact on terminal 12 (see section 7.4)
Increase the speed reference.
2
Press the key until the speed reference displayed is the desired value. The
longer the key is held down, the faster the value increases.
Cancel Auto Restart sequence.
Press the key.
RESET
RESET
Table 1.2 – VSM500 Option Kits
Drive Input Rating
CE Filter Option Kit DeviceNet
Communication
Option Kit Internal Mount External Mount
115V, 230V
Single Phase VSM-CE-1I VSM-CE-1E
DNVSM500
230V, 460V
Three Phase VSM-CE-3I VSM-CE-3E