Rockwell Automation SP600 User Manual Version 3.0 - Manual (Page 99)

Programming Basics 10-5
10.3.2 Restricting Access to Other Parameter Levels
The LCD OIM provides the option to restrict access to other
parameter levels. This feature requires the use of a user-defined
password when an attempt to change the access level is made.
To set the access level password, select the Password icon from
the main menu. See figure 10.4. The password value can range
from 1 to 9999. A value of 0 disables the password (factory default).
You must either select Logout or return to the process display
screen to activate the password.
When you enter the password, you can change access levels until
you select Logout or return to the process display screen, which
re-activates the password. Refer to section B.8 in Appendix B for
information about the process display screen.
Note that once the password is enabled, you will also be prompted
to enter the password to access the Set Acc Lvl PW option.
This option is not supported in the VS Utilities software.
If There is More Than One OIM Connected to the Drive
Note that setting or changing the access level password on one
OIM will set or change the access level password for all OIMs
connected to the drive.
!
ATTENTION: It is the user’s responsibility to determine how
to distribute the access level password. Reliance Electric is
not responsible for unauthorized access violations within the
user’s organization. Failure to observe this precaution could
result in bodily injury.
Figure 10.4 – Setting the Access Level Password
Auto Stopped
Main Menu
Password
P0: SP600
Password:
Set Acc Lvl PW
Set Wrt Prot PW
Set Access Lvl
Set Acc Lvl PW:
0 New Code:
Increase/decrease
value
Move placeholder
Highlight option Highlight Password icon
Password:
Set Wrt Prot PW
Logout
Set Acc Lvl PW
Highlight Logout
Activate password
Monitor Lang
>>