Rockwell Automation 57C329 Remote I/O Communications, AutoMax User Manual
Rockwell Automation Equipment
This manual is related to the following products:
Table of contents
Document Outline
- J-3606-4, AutoMax Remote I/O Communications
- Table of Contents
- 1.0 - Introductions
- 2.0 - Mechanical/Electrical Description
- 3.0 - Installation
- 3.1 AutoMax Remote I/O Coaxial Cable System Components
- 3.2 Installation Planning
- 3.3 Cable System Protection and Isolation Recommendations
- 3.4 Cable System Construction
- 3.5 Module Installation
- 3.6 Module Replacement
- 3.7 Adding a Slave Drop to the Remote I/O Network
- 3.8 Disconnecting a Slave Drop from the Remote I/O Network
- 3.9 Remote I/O Network Coaxial Cable Maintenance
- 4.0 - Programming
- 5.0 - Programming Terminal Communications
- 6.0 - Diagnostics And Troubleshooting
- 6.1 The Remote I/O Module's OK LED is Off
- 6.2 Error Code A is on the Remote I/O Module's 7-Segment Display
- 6.3 Remote I/O Network Failures
- 6.4 The Shark Interface Module's CPU OK LED is Off
- 6.5 The Shark Interface Module's COM OK LED is Blinking
- 6.6 All LEDs on the Remote I/O Head or Remote Drive Interface Head are Off
- 6.7 Error Code A is on the Remote I/O Head or Remote Drive Interface Head 7-Segment Display
- 6.8 The Remote I/O Head's Rail Fault LED is On
- 6.9 Error Code 31 is on the Processor Module's LED Display
- A - Hardware Technical Specifications, Remote I/O Communications
- B - Block DiagramsJ-3012-3, Automate DCS 5000/AutoMax Digital I/O Rails and Module
- C - RS-232 Port Pinout
- D - Remote I/O Code, Module, Head, Drive Interface Head
- E - Schematics
- F - Network Cable Specifications
- G - Cable System Component List
- H - Remote I/O Network Specifications
- J - Glossary of Terms
- K - Fiber-Optic Remote I/O Network Installation Guidelines
- K1.0 Introduction
- K2.0 Installation
- K3.0 Diagnostics And Troubleshooting
- Index
- Back Cover