Rockwell Automation 57C329 Remote I/O Communications, AutoMax User Manual
Page 83

5Ć7
If the entered rail location exists but has not yet been defined as
INPUTor OUTPUT,the following prompt will be displayed
(M/N 57C330 only):
This register has not been defined as INPUT or OUTPUT. If you
continue and write data to this register, it will be defined as an
output. Do you wish to continue and define this register as
output? (Y/N)
If you enter anything other than Y" (Yes), the operation will be
terminated. If Y" is entered, the register will be defined as OUTPUT
and the operation will continue. You will be prompted:
NEW DATA: Enter the new data followed by a carriage return. The
data can be entered in any one of the following formats:
HEX:
(Hexadecimal) Enter a leading 0, then any hexadecimal
characters 0 through F. The data is rightĆjustified if less
than four hexadecimal characters are entered.
DEC:
(Decimal) Enter data using any digits 0 through 9.
BIN:
(Binary) Enter a leading B, then any valid combination
of 1s and 0s. The data is rightĆjustified if less than 16
bits are entered.
The WRITE function will then display the current values of all registers
located at the specified port using the following display format:
REGISTER HEX DEC BIN