Rockwell Automation 2705-ND1 Keypad Development Software - Manual (Page 63)

Chapter 7
Message Operations
7–28
If you try to renumber a message onto itself (target and source numbers are
the same), the following message displays:
Press [C] to exit and return to the Messages menu.
If you try to renumber a message to an existing message, the following
message displays.
Press [C] to exit and return to the Messages menu.
If you enter start and increment values that result in a target message number
greater than 120, this message displays:
Press [C] to exit and return to the Messages menu.