Rockwell Automation 2705-ND1 Keypad Development Software - Manual (Page 116)

Chapter 10
Managing Message Files
10–11
The Copy File(s) function allows you to copy:
•
a single file to another file in the same directory
•
a single file to another directory (with or without the same file name)
•
multiple files to another directory (with the same file names)
The copy operation affects only those files previously selected with the
Select File(s) function. Selected files are shown in the File Picks window to
the left of the Files menu.
Select Copy File(s) from the Files menu. Highlight Copy File(s), then press
[Enter] or just press [C]. If you didn’t select a file first, this message shows:
Important: You must select files before you can copy them.
Otherwise a window opens and prompts you to specify a file destination.
Enter a file name with or without the .KPD extension, then press [Enter].
The file is created in the default program directory.
To copy FILE5.KPD to TESTFILE.KPD in the default directory, enter
TESTFILE in the window.
Note: If FILE5.KPD was selected from All DOS Files, TESTFILE is copied
without the .KPD extension.
Copying Files