Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive - Air-Cooled (A Frame) - Manual (Page 141)

Operator Interface 3-67
7000 “A” Frame 7000A-RM001A-EN-P – January 2011
Upload to Memory Card
The parameters are read from the drive and stored on a memory card
by pressing the [F4] key. The operator interface will enter the
DIRECTORY screen in which a parameter filename can be entered.
Refer to the section entitled “Enter a filename”. When the filename
has been obtained, the TRANSFER: PARAMETERS screen such as
that in Figure 3.94 will be displayed, showing the filename,
indicating the operation you are about to perform and showing the
current status of the operation.
Figure 3.94 – Transfer File Parameters
The screen will then ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. Pressing the [F4] key may
restart an aborted transfer or one that failed. To select or enter a
different filename, press the [F7] key.
Download from Memory Card
The parameters are read from a memory card and written to the drive
by pressing the [F2] key. The operator interface will enter the
DIRECTORY screen from which an existing parameter filename can
be selected or entered. Refer to the sections entitled “Select a
filename” and “Enter a filename”. When the filename has been
obtained, the TRANSFER: PARAMETERS screen similar to that
shown in Figure 3.94 (except the operation will show “FILE TO
DRIVE”) will be displayed, showing the filename, indicating the
operation you are about to perform and showing the current status of
the operation.
The screen will then ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. Pressing the [F4] key may
restart an aborted transfer or one that failed. To select or enter a
different filename, press the [F7] key.