Rockwell Automation 1771-PD PID MODULE (+DU) - Manual (Page 83)

Programming
Chapter 3
3Ć40
Table 3.I
W60 Lower Byte Programming Error Codes
BCD Code Dynamic Block Word Errors
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
Loop 1 constants block was not transferred in the load/enter
sequence.
W19 has illegal soft fault code 011, 101, or 110.
W20 has illegal BCD value.
W21 is above maximum or has illegal BCD value.
W22 is above maximum or has illegal BCD value.
W23 is above maximum or has illegal BCD value.
W24 has illegal BCD value.
W25 has illegal BCD value.
W26 has illegal BCD value
W27 has illegal BCD value.
W28 is above maximum or has illegal BCD value.
W29 is above maximum, has illegal BCD value, or is less than
W28.
W30 has cascade or decouple selected when only loop 1 is
selected.
W31 has illegal BCD value.
W32 has illegal BCD value or is less than or equal to W31
value..
W33 has illegal BCD value.
W34 has illegal BCD value.
W35 has illegal BCD value.
W36 has illegal BCD value.
BCD Code Loop 2 Word Errors
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
Loop 2 constants block was not transferred in the load/enter
sequence.
W39 has illegal soft fault code o11, 101, or 110.
W40 has illegal BCD value.
W41 is above maximum or has illegal BCD value.
W42 is above maximum or has illegal BCD value.
W43 is above maximum or has illegal BCD value.
W44 has illegal BCD value.
W45 has illegal BCD value.
W46 has illegal BCD value.
W47 has illegal BCD value.
W48 is above maximum or has illegal BCD value.
W49 is above maximum, has illegal BCD value, or is less than
W48.
Not used
W51 has illegal BCD value.
W52 has illegal BCD value or is less than or equal to W51.
W53 has illegal BCD value.
W54 has illegal BCD value.
W55 has illegal BCD value.
W56 has illegal BCD value