Rockwell Automation 1761-NET-DNI DeviceNet Interface (DNI) - Manual (Page 61)

Publication 1761-UM005B-EN-P - October 2006
Setup, Programming, and Troubleshooting 61
Using RSNetWorx to Modify Parameters
Once a DNI is placed on the network, double-click to open the EDS
file. All adjustable parameters that configure the DNI for operation are
set up through this configuration utility. The illustration below shows
the RSNetWorx Device Configuration screen with each DNI
configurable parameter.
Perform this procedure to configure any of the parameters.
1. Highlight the parameter.
2. Click the Modify Parameter button, or double-click on the
parameter.
3. For DNI Series A, set DNI mode to Standby. For DNI Series B,
set I/O Scan Enable to Disable.
4. Change the parameter data as needed.
5. For DNI Series A, set DNI mode to Operational. For DNI Series
B, set I/O Scan Enable to Enable.
6. For more detailed information click on Help.
Once a parameter is changed or after all parameters are
changed, click Download to Device.