Rockwell Automation 1761-NET-DNI DeviceNet Interface (DNI) - Manual (Page 55)

Publication 1761-UM005B-EN-P - October 2006
Setup, Programming, and Troubleshooting 55
Setting Up Network
Configuration Software To configure the DNI, you must set up your network configuration
software and follow the configuration procedures. The initial set up is
only performed once. After the files have been saved by your network
configuration software, they are stored on the computer.
Setting Up DNI Configuration Software Utility
No initial set up is required to use the DNI Configuration Software
Utility.
Setting Up RSNetworx
With RSNetworx open, install 1761DNI2.EDS for DNI Series A
(1761DNI3.EDS for DNI Series B) and 1761DNI.ICO using the EDS
install utility (in the Utilities menu of RSNetworx).
Follow these steps to load both DNI files into RSNetWorx.
1. Start RSNetWorx.
2. With RSNetWorx open, select the View Tools Menu.
3. Select EDS Wizard.
4. Select Register an EDS file and follow the prompts.
RSNetWorx is now set up to recognize and configure the DNI.
5. To locate 1761-NET-DNI in RSNetWorx file list, double-click on
the following folders:
– Rockwell Automation - Allen-Bradley Company