Rockwell Automation Logix5000 Controllers Add-on Instructions Programming Manual - Manual (Page 83)

Using Add-On Instructions Chapter 3
Using the Jog command in function block diagram
Any parameter can be made visible or invisible except those defined as required.
Required parameters are always visible. If the parameter is required, you will see it
checked in the Properties dialog box.
1. Click Properties for the instruction.
2. Select the Vis check box of the Jog parameter to use it in your diagram.
3. Click OK.
Rock well Automati on Publication 1756- PM010F-EN-P - Oct ober 2014 83