Rockwell Automation Logix5000 Controllers Add-on Instructions Programming Manual - Manual (Page 77)

Using Add-On Instructions Chapter 3
3. Click to display the instruction help for any instruction
in the browser.
4. Click OK.
Follow this procedure when you want to use an Add-On Instruction in one of
your routines.
1. Open the Add-On Instruction folder in the Controller Organizer and
view the listed instructions.
If the instruction you want to use is not listed, you need to do one of the
following:
• Create the instruction in your project.
• Copy and paste an instruction into your project.
• Get the file for an exported instruction definition and then import the
instruction into your current project.
2. Open the routine that will use the instruction.
3. Click the Add-On tab on the instruction toolbar.
4. Click the desired Add-On Instruction, for example Simulation, and drag
the instruction from the toolbar into the routine.
Including an Add-On
Instruction in a routine
Rock well Automati on Publication 1756- PM010F-EN-P - Oct ober 2014 77