Using add-on instructions, Introduction, Accessing add-on instructions – Rockwell Automation Logix5000 Controllers Add-on Instructions Programming Manual User Manual
Page 75: Using the add ladder element dialog box, Chapter 3

Chapter 3
Using Add-On Instructions
Add-On Instructions are used in your routines like any built-in instructions. You
add calls to your instruction and then define the arguments for any parameters.
The Add-On Instruction can be used in any one of the Ladder Diagram, Function
Block, or Structured Text languages (including Structured Text within Sequential
Function Chart actions). The appearance of the instruction conforms to the
language in which it is placed.
The Add-On Instructions in the project can be accessed from any of the normal
instruction selection tools.
The instruction toolbar has an Add-On tab that lists all of the currently available
Add-On Instructions in the project.
Important:
Safety Add-On Instructions can be used only in safety routines, which are currently restricted to
ladder logic. Safety Add-On Instructions are shown in the Language Element toolbar only
when the routine is a safety routine.
Follow these instructions to access the Add (language) Element dialog box.
1. Press Alt + Insert anywhere in the editor or right-click the logic in the
Editor and select Add Element.
Introduction
Accessing Add-On
Instructions
Using the Add Ladder
Element dialog box
Rock well Automati on Publication 1756- PM010F-EN-P - Oct ober 2014
75