Rockwell Automation Logix5000 Controllers Add-on Instructions Programming Manual - Manual (Page 82)

Chapter 3 Using Add-On Instructions
The following procedures demonstrate how to use the Jog parameter of the Motor
Starter Add-On Instructions.
Using the Jog command in ladder diagram
The first rung sets the Jog bit of Motor_Starter_LD = Jog_PB.
Use another instruction, an assignment, or an expression to read or write to the tag name of the parameter. Use this format for the tag name of the parameter.
Add_On_Tag.Parameter
Where Is
Add_On_Tag An instance tag defined by the Add On data type.
Parameter Name of the parameter.
82 Rockwell Automation Publication 1756-PM010F-EN-P - October 2014