Rockwell Automation Logix5000 Controllers Add-on Instructions Programming Manual - Manual (Page 48)

Chapter 2 Defining Add-On Instructions
If you want to select which specific tags and values to copy, click the pull-down
arrow of the copy default values icon and select Copy Specified Values.
The Copy Default Values dialog box shows the current default values for the
parameters and local tags, and the instance tags where the Add-On Instruction is
used or referenced.
Select the check boxes to select which values to copy to which tags, and click OK.
Follow these steps to enter logic into your project.
1. In the Controller Organizer, expand the Add-On Instructions folder.
2. Expand the instruction and double-click the logic routine to open.
Creating logic for the
Add-On instruction
48 Rockwell Automation Publication 1756-PM010F-EN-P - October 2014