Rockwell Automation 1784-PCMK PCMK Communication Card Installation Manual - Manual (Page 37)

Publication 1784-UM519C-EN-P - September 2006
Chapter
4
Install the 1784-PCMK Driver for the Windows NT
Operating System
What’s in This Chapter?
Refer to this chapter to perform the following:
Locate the Windows NT Driver
The Windows NT driver for the PCMK card is built into RSLinx software, version 1.7
or later. Rockwell Automation has published detailed instructions for configuring
this driver. You can find these instructions by visiting
http://support.rockwellautomation.com, then selecting Technical Support.
Topic Page
Locate the Windows NT Driver 4-1
IMPORTANT
Be aware there are several different third party plug and play
emulators, such as SystemSoft’s CardWizard and Softex/
Phoenix’s CardExec, that may be installed on some computers
running the Windows NT operating system. Knowledgebase
document 10088 refers to solutions when you configure
computers with third-party, plug and play emulators.
Knowledgebase document 10410 also describes procedures for
using SystemSoft’s CardWizard software. Access the
Knowledgebase at http://support.rockwellautomation.com.
Click Technical Support, then Knowledgebase.
IMPORTANT
You can have only one 1784-PCMK card configured in the
Windows NT operating system. The Windows NT operating
system does not differentiate between the card slots. If you insert
more than one PCMK card into your PC, only one will be
available for use.