Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 155)

Rockwell Automation Publication 1783-UM003I-EN-P - March 2014 155
Manage the Switch via the Studio 5000 Environment Chapter 5
Monitor and Reset the Switch In the software, you can monitor and reset the switch by accessing the Module
Properties screen.
Field Description
Identification Displays the following switch information:
• Vendor
• Product Type
• Product Code
• Revision
• Serial Number
• Product Name
Status Displays the following status information:
• Major/minor Fault Status
– None
– Recoverable
– Non-recoverable
• Configuration
– Non-default Configuration
– Default Configuration
• Owned
– Yes. There is an I/O connection.
– No. There is not an I/O connection.
• Module Identity
– Match. Agrees with what is specified on the General Tab. In order for the Match condition to exist, the vendor, product
type, product code, and major revision must agree.
– Mismatch. Does not agree with what is specified on the General tab.
The Module Identity field does not take into account the Electronic Keying or Minor Revision selections for the switch that
were specified on the General tab.
Refresh Click to refresh the tab with new data from the module.
Reset Module Click to perform a switch reset (power cycle) with the current configuration file. If the Password Confirmation dialog box
appears, enter a password.
IMPORTANT: Resetting a module causes all connections to or through the module to close. This can result in a loss of control.