Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 103)

Rockwell Automation Publication 1783-UM003I-EN-P - March 2014 103
Manage the Switch via the Device Manager Web Interface Chapter 4
Configure DHCP To use DHCP persistence, you must first enable DHCP and set up the IP address
pool. Then you must assign a specific IP addresses to each port.
Set up the DHCP Server
To enable the DHCP Server mode on the switch, do the following.
1. From the Configure menu, choose DHCP.
2. Check Enable DHCP.
3. To enable DHCP snooping, check DHCP Snooping.
DHCP snooping restricts the broadcast of DHCP requests beyond the
connected switch. This means that devices receive address assignments
from only the connected switch. This option is available only on VLAN
interfaces. To enable DHCP Snooping on a specific VLAN, check DHCP
Snooping for the specific VLAN in the DHCP Pool table.
4. To reserve an address pool to only the devices that are specified in the
DHCP persistence table, check Reserved Only in the DHCP pool table.
DHCP requests from ports not in the persistence table or from another
device (switch) are ignored. By default, this option is disabled and the
Reserved Only checkbox is cleared.
5. Click Submit.