Rockwell Automation 1770,D17706.5.21 SMART TRANSMITTER TOOLKI - Manual (Page 52)

Appendix B
Codes
B-2
Smart Transmitter Interface Error Codes
Integer Word 33
General Errors
Code (decimal) Code (hex) Definition Description
0 00 No Error The Smart Transmitter Interface processed the last received command, and
no errors were detected.
1 01 Downloading Firmware The Smart Transmitter Interface firmware is being upgraded over the
RSĆ232C port. The last received command cannot be processed.
2 02 No Corresponding BTW The Smart Transmitter Interface received a BTR but does not know what data
is being requested. All BTRs must be preceded by a BTW indicating what
response to return in a BTR.
3 03 Command Still in
Progress
The Smart Transmitter Interface is still obtaining the HART Response from a
field device and cannot respond with the requested data. The programmable
controller should reissue the BTR request to obtain the response.
Command Errors
Code (decimal) Code (hex) Definition Description
16 10 Invalid Command The Smart Transmitter Interface command is invalid and cannot be
processed.
17 11 Invalid Channel Number The Smart Transmitter Interface channel number is invalid. The command
cannot be processed.
18 12 Invalid HART Message The HART packet encapsulated within a Smart Transmitter Interface packet is
invalid and cannot be forwarded to a field device.
19 13 Invalid Channel List The channel list provided with the Enable Burst Monitor Mode command
contains an invalid entry or is incorrectly terminated. The command cannot be
processed.
20 14 Invalid Parameter An invalid parameter is provided with the Smart Transmitter Interface
command and so it cannot be processed.
21 15 Invalid Control An invalid control byte is included with the Smart transmitter Interface
command. The command cannot be processed.
22 16 Invalid DF1 Packet Length The length of the DF1 packet is not consistent with the length specification in
that packet. The command cannot be processed.
Device Errors
Code (decimal) Code (hex) Definition Description
32 20 Burst Mode Device Not
Communicating
The Smart Transmitter Interface is not receiving burst data from a field device
in burst mode. Either Burst mode has been turned off in the field device or it is
too busy to send burst table data. The error code is cleared once the Smart
Transmitter Interface receives new burst data from the device.
33 21 No Response Received
From Device
The Smart Transmitter Interface has not received a response from a field
device after exhausting all retry attempts.
34 22 No Valid Burst Data The Smart Transmitter Interface does not have data in its Burst Monitor Table
for the requested channel. Either the Smart Transmitter Interface was not
commanded to monitor the channel for burst data, or the field device is not in
burst mode.