Rockwell Automation 198 Series C Modular DeviceNet Starter Auxiliary User Manual - Manual (Page 27)

Operation 3-6
Publication 198-UM002A-EN-P December 2001
4. Select the MDSA device and press the 2. button. After RSNetworx has finished
updating the network the following screen will appear:
5. Choose the desired node address and click the Apply button.
6. Click the Exit button. The unit will reset and power up at the new node address.
7. Re-browse the network. The MDSA should appear at the new node address.
The final way to set the node address is by directly setting the node address switches found on
the MDSA DeviceNet module.
0
4 6
8 2
0
4 6
8 2
Node Address
MSB LSB
Address 63 Shown