Rockwell Automation 825-MDN Smart Motor Manager DeviceNet Communication Card User Manual - Manual (Page 46)

Publication 825-UM002A-EN-P - December 2000
A-24
Parameters Supported, Continued
Parameter
No.
®=read-only
Parameter Name Object
Mapping
Description Data
Type Units Min/
Max Default
232 ® ➊ Sp Sw Trip Delay 0x2C-1-171 Speed Switch Trip Delay USINT 0.1 s 1…50 5
233 ® ➊ SMM Revision 0xB4-1-12 SMM/CET4 firmware revision UINT
234 ➊ Aux2 Pr FltState 0x29-1-142 Aux relay #2 behavior on a trip condition.
0 = “Go to Value”, 1= “Hold Last State” BOOL 0…1 0
235 ➊ Aux2 Pr FltValue 0x29-1-143 Go To Value setting for parameter #234.
0 = OFF, 1= On BOOL 0…1 0
236 ➊ Aux2 Dn FltState 0x29-1-144 Aux relay #2 behavior on a comm. fault
condition. 0 = “Go to Value”, 1= “Hold Last
State” BOOL 0…1 0
237 ➊ Aux2 Dn FltValue 0x29-1-145 Go To Value setting for parameter #236.
0 = OFF, 1= On BOOL 0…1 0
238 ➊ Aux2 Dn IdlState 0x29-1-146 Aux relay #2 behavior on a comm. idle
condition. 0 = “Go to Value”, 1= “Hold Last
State” BOOL 0…1 0
239 ➊ Aux2 Dn IdlValue 0x29-1-147 Go To Value setting for parameter #238.
0 = OFF, 1= On BOOL 0…1 0
240 ➊ Aux3 Pr FltState 0x29-1-148 Aux relay #3 behavior on a trip condition.
0 = “Go to Value”, 1= “Hold Last State” BOOL 0…1 0
241 ➊ Aux3 Pr FltValue 0x29-1-149 Go To Value setting for parameter #240.
0 = OFF, 1= On BOOL 0…1 0
242 ➊ Aux3 Dn FltState 0x29-1-150 Aux relay #3 behavior on a comm. fault
condition. 0 = “Go to Value”, 1= “Hold Last
State” BOOL 0…1 0
243 ➊ Aux3 Dn FltValue 0x29-1-151 Go To Value setting for parameter #242.
0 = OFF, 1= On BOOL 0…1 0
244 ➊ Aux3 Dn IdlState 0x29-1-146 Aux relay #3 behavior on a comm. idle
condition. 0 = “Go to Value”, 1= “Hold Last
State” BOOL 0…1 0
245 ➊ Aux3 Dn IdlValue 0x29-1-153 Go To Value setting for parameter #244.
0 = OFF, 1= On BOOL 0…1 0