4running up the conditioner, Running up the conditioner, Warning – MacDon HC10 for D-Series User Manual
Page 69: Caution
3.
From the rear of the conditioner, locate tool at centre of
rolls as shown and manually turn rolls to limits of tool.
Rolls will engage the tool if timing is correct.
4.
Manually turn rolls to release tool.
WARNING
Remove tool from rolls and return it to storage
location before starting machine.
5.
Replace tool on conditioner with washer and wing nut.
6.
If roll timing requires adjusting, refer to section
Checking and Adjusting Roll Timing, page 81
Figure 3.69
A - Start position
B - Gauge position
3.12.4
Running Up the Conditioner
CAUTION
Never start or move the machine until you are sure all bystanders have cleared the area.
CAUTION
Clear the area of other persons, pets etc. Keep children away from machinery. Walk around the machine
to be sure no one is under, on or close to it.
CAUTION
Before investigating an unusual sound or attempting to correct a problem, shut off engine, engage
parking brake and remove key.
Refer to the windrower unloading and assembly instructions or operator’s manual for windrower operating
instructions.
To run up the conditioner, follow these steps:
1.
Start windrower and run the machine. Operate the conditioner slowly for 5 minutes, watching and listening
FROM THE OPERATOR'S SEAT for binding or interfering parts.
2.
Run machine for 15 minutes.
3.
Perform the run-up check as listed on the "Predelivery Checklist", (yellow sheet attached to this instruction), and
the header run-up check to ensure the machine is field-ready.
169254
61
Rev. D