MacDon HC10 for D-Series - Manual (Page 55)

UNLOADING AND ASSEMBLY
10. Route the conditioner pressure hose (A) (orange cable
tie) behind the motor and attach it to the coupler (B).
Figure 3.43
11. Loop the conditioner return line (A) up over top of the
couplers and connect to the pressure port (B) on the
motor. Ensure all hoses will be clear of tractor tires.
Figure 3.44
3.7.2 Attaching Hydraulics: All Headers Except 15-Foot
To attach hydraulics to all headers (not including 15-foot),
follow these steps:
1. Identify the hydraulic coupler components shown in
illustration at right.
2. Remove hose cover (A) from left-hand coupler mount.
3. Disconnect the side draper return hose (C).at the main
return tee (see item [E] in illustration at right).
Figure 3.45
A -Hose Cover B - Coupler Mount
C -Side Draper Return D - LH Draper Case Drain
E - To Side Drapers (Pressure) F - Case Drain Coupler
G - Knife/Conditioner Pressure H - Header Return
169254
47
Rev. D