beautypg.com

Unloading and assembly – MacDon HC10 for D-Series User Manual

Page 56

background image

UNLOADING AND ASSEMBLY

4.

Detach knife motor case drain line (D) from bulk head
fitting at coupler mount (A).

5.

Install conditioner case Tee fitting (B) and conditioner
case drain line (C).

6.

Remove knife drive hose (G).

Figure 3.46

A - Coupler Mount

B - Conditioner Case Tee

C - Conditioner Case Drain

D - Knife Motor Case Return

E - Header Return Tee

F - Knife Return

G - Knife Drive Hose

7.

Install check valve tee (A) on the main return tee (E).

NOTE: Arrow on check valve tee fitting should

face up.

8.

Install the feed draper return hose (C) with the blue tie
to the check valve tee (A).

9.

Reinstall the side draper return hose (B) that was
removed in step

3., Attaching Hydraulics: All Headers

Except 15-Foot, page 47

to the new check valve

tee (A).

10. Connect conditioner return hose (D) with union to

Knife drive hose (F) removed in step

6., Attaching

Hydraulics: All Headers Except 15-Foot, page 48

.

11. Attach Conditioner drive hose (G) with orange tie to the

coupler where knife drive hose was removed in step

6., Attaching Hydraulics: All Headers Except 15-Foot,
page 48

.

12. Bundle the hoses with cable ties as required. Ensure

hoses do not contact sharp edges.

13. Replace hose cover.

Figure 3.47

A - Check Valve Tee

B - Side Draper Motor Return

C - Feed Draper Return

D - Conditioner Return

E - Header Return Tee

F - Knife Drive Hose

G - Conditioner Drive

169254

48

Rev. D