MacDon HC10 for D-Series - Manual (Page 43)

UNLOADING AND ASSEMBLY
3.5 Installing the Feed Deck
To install the feed deck, follow these steps:
1. Slide feed deck (A) under header opening from the
rear. Deck drive motor faces aft.
Figure 3.13
2. Set front of deck (A) onto the rock grate and slide the
feed deck forward until the locating pins (B) reach the
pockets on the rock grate.
3. Lift the rear of the feed deck so the mounts on the
deck clear the brackets on the leg and slide deck
forward until mounting pins are fully positioned inside
the pockets.
Figure 3.14
4. Install two 1/2 x 1.25 in. long carriage bolts at rear
mounting brackets.
Figure 3.15: LH Side Shown
169254
35
Rev. D