Model hc10 hay conditioner predelivery checklist, Caution – MacDon HC10 for D-Series User Manual
Page 151
Model HC10 Hay Conditioner Predelivery Checklist
Perform these checks and adjustments prior to delivery to your Customer. Refer to Unloading and Assembly
Instructions for adjustment details. The completed checklist should be retained either by the Operator or the Dealer.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages, which bring your attention
to hazards and unsafe practices.
Conditioner Serial Number: _____________________________________________
Item
Reference
Check for shipping damage or missing parts. Be sure all shipping
dunnage is removed.
—
Check roll drive belt tension.
3.12.1 Checking Roll Drive Belt
Tension, page 59
Check conditioner roll gap, timing, and alignment.
3.12.2 Checking Roll Gap, page 60
and
3.12.3 Checking Roll Timing, page 60
Check rear and side forming shields evenly set to desired position.
3.9 Installing the Forming Shield, page
53
Grease all bearings.
3.11 Lubricating the Conditioner, page
56
Check roll intermesh hardware is securely tightened.
4.9.2 Adjusting Roll Gap, page 80
Check hydraulic hose routing.
4.3 Attaching Hay Conditioner to
Header, page 65
RUN-UP PROCEDURE
3.12.4 Running Up the Conditioner,
page 61
Check reverse operating mode.
See windrower manual.
Check hydraulic hose routing for clearance when raising or
lowering header.
—
POST RUN-UP CHECKS. STOP ENGINE.
—
Check for hydraulic leaks.
—
Check belt drive for alignment and heated bearings.
Check manuals in windrower cab.
3.12.5 Storing Manuals, page 62
Date checked:
Checked by:
143