MacDon HC10 for D-Series - Manual (Page 60)

UNLOADING AND ASSEMBLY
6. Position deflector (A) on cover as shown and
install with hex bolt (B) and flange nut removed in
previous step.
7. Tighten flange nut enough to hold deflector (A) in
position, but still allow deflector to move.
Figure 3.54
A - Side Deflector B - Hex Bolt
C - Bolt (referred to in next step)
8. Install bolt, washers, and handle nut (A) as shown.
Rubber washer (B) must be positioned between metal
washers (C).
9. Tighten handle nut (A) against cover to lock deflector
in desired position.
10. Repeat for the other deflector.
Figure 3.55
11. Invert forming shield to installation position as shown.
Figure 3.56
169254
52
Rev. D