MacDon HC10 for D-Series - Manual (Page 63)

UNLOADING AND ASSEMBLY
3.10 Attaching to a Windrower
Refer to the windrower unloading and assembly
instructions or operator’s manual for instructions on
attaching the header to an M-Series Self-Propelled
Windrower.
Once the header and windrower are attached, follow
these steps:
1. Lift the aft end of the forming shield and attach straps
(B) to pins (A) on windrower frame.
2. Retrieve washers and hairpins from shipping bundle
and install to secure strap. Use the middle hole and
adjust height to suit the crop.
Figure 3.61
169254
55
Rev. D