beautypg.com

Unloading and assembly – MacDon HC10 for D-Series User Manual

Page 42

background image

UNLOADING AND ASSEMBLY

6.

Remove the hose guide (A) located near the left-hand
center leg. (For 20 ft. and larger headers, remove this
support from its mounting position on sheet metal hose
cover.)

Figure 3.11: 15 ft Header Shown

7.

Attach hose assembly (A) onto the left-hand center leg
and install nut on lower bolt (C). Ensure correct hole is
used when attaching hose assembly (use hole (D) for
15-foot headers).

NOTE: For headers with a sheet metal hose

cover, install bolts from the outboard side.

8.

Install other bolt (B) through bracket, spacer, and hose
assembly and secure with a nut.

9.

Tighten both bolts.

Figure 3.12: 20–35 ft Header Shown

A - Hose Assembly

B - Bolt

C - Mounting Position for 20–35-Foot Headers
D - Mounting Position for 15-Foot Headers

169254

34

Rev. D